|
Main Features (Machine)
Low maintenance.Closed
loop structure for low electrical noise(patent).
Untouched sensor and SCR system keep durable and low noise.
For added protection,the electrical components are located on the top of the
machine.
Reduced vibration and improved accuracy are achieved using a five phase
motor.
International standard components are uniformly used where
possible,providing the user the option to source spare parts locally,spare
parts are interchangeable.
The use of superior materrials and components(superior cast iron,linear
slides and ball screws)ensure high rigidity,accuracy,and durability.
Multiple wire speeds for different cutting parameters and ease of wire
installation.
The machine has been designed specifically to meet the needs of press and
plastics tooling applications.
¡¡ |
|
Main Features
(Controller):
PC Based industrial
computer utilising EPROM technology for improved reliability and systems
protection.
Two central processing units (CPU) to enable programming while cutting.
Graphical gap voltage display (patent)
Graphical programming system including such features as: mirror, move,
rotate, divide, scale, zoom, line, circle, radii, standard/special curve,
gear, tangent of line and circle, trim, clear, off-set and smooth radius.,
Can accept DXF or G-Code from AutoCAD and other major CAD/CAM systems via
floppy disk.
Optional scanning software or full scanning system available.
Programmable taper of up to 60 degrees.
Four-axis synthesis(different profile top to bottom).
2D or 3D cutting simulation and real time machining trace.
Edge finding and auto centring.
Invert cutting (Invert the cutting path).
Initiate start point(can return to initial start hole position while wire
broken).
Auto Back-off and manual Back-off or go back to last point,then resume
cutting.
Pause cutting.Restart cutting.
System can memorises the point on the cutting path when an error occurs or
when there is a wire breakage.It then can resume cutting from that point
when the error is rectified.
Battery back up.Complete data relention.
Auto programming for jumping mold.
Graphically check any segment of the programmed path with the ZOOM function.
Auto reset of UV axis when the job is completed.
International G-Codes.switch between graphics and G-Code easily.
No load output voltage:105V.
The on-time width Ton:2,4,8,16,32,64,128¦Ìs.
Max. short circuit current>8A.
Dimension of controller:600*600*1750mm
Other specifications:
Max. cutting speed:100mm2/min.
Optimum furface finish:Ra>2.0¦Ìm.
wire diameter:§æ0.12~0.22mm
wire speed:4 levels adjustable
Dielectric solution:oil NG-1(1:20),Dielectric soap NG-1(1:20~25)
Max. working current:6A.
Power supply:1-N 50Hz/60Hz,220VAC or 3-N 50Hz,380VAC
Power consumption:less than 1.2KVA
|
