UNIVERSAL DIVIDING HEAD:

ptfw80

Features:

    This dividing head is a revised model with new design. In Comparison with old model FW universal dividing head the new model has a good looking and is available to carry out indexing for any desired angles otherwise, a face plate can be directly mounted onto the spindle nose.

      This dividing head is one of accessories for milling machine. It can help the maching in dividing the workpieces held between two centers or on a chuck into any desired angles. With the help of it, grooves; slots; gears; helical gears; Archimedes cams and helical curves can be finished on the machines.

ACCESSORIES:

   (1):Tailstock  (2):Gear bracket  (3): Change gear   (4):Jack Center  (5): Carrier

    (6)Hole plate  (7): Flange   (8):Vernier dial   (9): 3-jaw chuck  (10): Face plate (Specially ordered)

MAIN SPECIFICATIONS:    (mm/in.)

Type

PTFW80

PTF11 100A

PTF11 125A

PTF11 160A

Center height

80/3.15

100/3.94

125/4.92

160/6.30

Tilting angle of the spindle

 ¡Ý95º ;  ¡Ý5º

Rotating angle of the spindle for one complete revolution of the dividing handle

 9º
Min. value of the vernier 10"
Worm gear ratio 1:40
Diameter of spindle register taper ¦µ36.541/¦µ1.441 ¦µ41.275/¦µ1.63 ¦µ53.975/¦µ2.13
Spindle taper bore (Morse) MT  NO.3 MT NO.4
Width of the locating key 14/0.55 18/0.71
Hole No. of hole plate first face 24,25,28,30,34,37,38,39,41,42,43
second face 46,47,49,51,53,54,57,58,59,62,66
Module of change gears 1.5/0.06 2/0.08
Teeth No. of change gears 25,25,30,35,40,50,55,60,70,80,90,100
Individual indexing error of the spindle for one complete revolution of dividing handle 60" ¡À45"
Accumulative indexing error in any each of the four quadrants ¡À1'
¡¡ ¡¡
¡¡